2024.02.13 Submitted to Journal
2024.02.15 with editor
2024.02.17 Transfer Pending (reject

(0) Thank | 蠢小葱

Is it necessary to consider the impact factor (IF) when selecting articles for publication?

(0) Thank | 八坂篷蔚

What is IF?

(0) Thank | 上清雨真

I feel that this journal has great potential. IF rose a lot last year.

(0) Thank | Barbie

Review speed: 6.0 | Submission acceptance rate: 50.0
Experience sharing: I feel this journal has great potential. It increased a lot if compared to last year

(0) Thank | 碧桃逸致

I advise everyone to be cautious about submitting articles, as the process is incredibly slow and rejections are made without any explanation! I'm done with this

(0) Thank | 金山盼烟

Review Speed: 3.0 | Submission Acceptance Rate: 5.0
Experience Sharing: I have submitted my paper for nearly three months, during which it has continuously shown "under review." Now I received this message: "The reviewers concluded that a summary of the literature on this topic was not of interest to the readers of this journal." Oh my, it took you three months to figure out that it is not suitable for the readers of this journal. I am speechless... It seems like they all treat authors like this. Be cautious when submitting

(0) Thank | 四风文雅

Review Speed: 6.0 | Submission Hit Rate: 5.0
Experience Share: Submitted on June 26th, rejected on November 7th, with "under review" status throughout. After four months, an email was sent saying it was still under review, with one reviewer's comments not returned. When it was rejected, there was no feedback, only a simple statement saying it did not match their readership. Very angry, also recommended a non-SCI journal

(0) Thank | 无妄念柏

Submitted to the journal for 3 days, still showing in the submission

(0) Thank | 四风文雅

The downward trend seems to be endless, will it break below 2? It has dropped significantly in just a year, even a 0.1 point should be cherished

(0) Thank | 凌霄高洁

I submitted my manuscript on December 17th, and it has been over two weeks now, still in 'with editor'. Is this normal? How long does it usually take for manuscripts to be with editor?

(0) Thank | Pag Edison

Submitted on October 21st, with editor on October 23rd, still waiting

(0) Thank | 风啸梓婷

Congratulations. My email address is zhongql90@163.com. Please let me know how much the layout fee is, thank you!

(0) Thank | 会心笑曼

Are you sure?

(0) Thank | 会心笑曼

Oh, the layout fee is $2500 on October 25, 2014??

(0) Thank | 会心笑曼

My email is zhongql90@163.com, if you know how much the layout fee is, please let me know, thank you!

(0) Thank | 会心笑曼

Hey, friends, how much is the layout fee?

(0) Thank | 会心笑曼

Review speed: 2.0 | Submission hit rate: 25.0 Experience sharing: Recently got one accepted. It's quite difficult to get accepted, based on my submission number, the acceptance rate is less than 25%. Few Chinese submit (or get accepted...), it belongs to a niche magazine. The review speed is quite fast. Submitted on June 5th, first review finished on July 22nd, revisions on August 19th, accepted on August 23rd. Good luck to those who come after!

(0) Thank | 北海利强

Layout fee is $2500?

(0) Thank | 凌霄高洁

I submitted my article to this magazine for the first time, and it got rejected within a week. They said they receive too many submissions, and it may be due to my writing style. Also, the magazine may have a small article quota, which makes it difficult to get published. However, they replied very quickly and didn't waste my time, so I will submit to another magazine

(0) Thank | 魔都寄琴

This cup is so unlucky that I changed to another magazine for the week

(0) Thank | 魔都寄琴

The amount of articles this year is a bit low, isn't it?

(0) Thank | 魔都寄琴

2 points and still in the 13th district? Which professional area is the 13th district?

(0) Thank | 凌霄高洁

Comrades, this magazine is SCIE, not SCI. I have had an article published in it before, JCR-13 zone! Zone 13!

(0) Thank | 绮兰小仙女

Submission success rate: 25.0 Experience sharing: Over 150 articles per year, with the latest submission being number 715. By this calculation, the success rate is lower than 20%

(0) Thank | 水丹酱大魔王